Base Station Offline Support

We are available 24*7 hours for your help

basestation-image

Check the LED light on base station

To begin investigating, first check the LED lights on the exterior of base station to decide if the system is online or not. New base stations have a solitary LED while more established base station has three/five LED lights.

In case you are not at a similar spot as your base station, introduce the application or sign in to your record

Base Sation with Single LED

Single LED base station is toward the front. Single-LED base station streaks blue or golden, depend upon the property standing.

In case you are not at a similar spot as your base station, introduce the application or sign in to your record

basestation-img
basestation=image1

Base Station with Multi LED

Driven lights on multi-LED base stations are on untouched low of the front base station. The center LED light is the Internet availability.

Base station: investigate

Assuming the base station is disconnected, follow these investigating steps:

1. Check the Ethernet link.

Benevolently ensure that your Ethernet link is safely associated with the base station and switch and that you are utilizing the Ethernet link that accompanied your framework just and no other.

2. Check the Power connector.

Benevolent, ensure that the force connector is safely associated with the rear of your base station and safely connected.

3. Then, at that point attempt to associate with the web from another gadget that is associated straightforwardly to your switch.

If you can't look from the Internet from gadget, you need to reestablish your switch's association with the Internet.

If you can peruse the Internet from the gadget then, at that point keep investigating.

4. Force cycle your base station.

To control cycle your base station, turn off the force connector from the power source, hang tight for around two minutes then reconnect the force connector to the power source. The base station takes around one to two minutes to begin. At the point when the force LED light and Internet LED light is strong green shading then your base station is associated with the Internet. On the off chance that the Internet LED light is golden shading, keep investigating.

5.Further, check your switch's DHCP (Dynamic Host Configuration Protocol) settings and the customer list.

Guarantee that DHCP setting is empowered and that switch's DHCP customer list provided an IP address to the base station as though it based, station shows up in the customer list.

6. And in case you were already ready to associate your base station to the Internet however presently can't interface then, at that point check the switch's security settings and firmware to guarantee that no progressions were made since the last time it was effectively associated.

You may need to on briefly premise, bring down the security settings on the switch or briefly place the base station in the DMZ (peaceful area) to preclude any firewall limitations. On the off chance that in the event that you roll out these improvements, power cycles your base station as prior portrayed in Step 4.

7. Now, check and ensure that ports 443 and 80 are open on your switch.

In the event that you don't deal with your Internet association, contact your IT division for help with any firewall or for switch setups. The base station can't associate through most intermediary workers. In this way, check with your IT group and Internet specialist co-op (ISP) about the approaches to sidestep any intermediary workers. You can ask your IT group to guarantee that ports 443 and 80 are open.